Installation-Parts Lower Strainer and Valve Kit For straining material from a material supply to a pump lower fluid inlet. Part No. 256653 400 psi (2.8 MPa, 28 bar) Maximum Working Pressure Important Safety Instructions Read all warnings and instructions in this manual. Save these instructions.
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risk. Refer back to these warnings. Additional, product-specific warnings may be found throughout the body of this manual where applicable. WARNING WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury.
Parts Parts 256653, Lower Strainer and Valve Kit 1 5 5 3 2 2 1 Apply sealant to all non-swiveling pipe threads. 2 Clean weekly. Ref. 1 2 3 3a 5 Part 109077 C20487 101078 180199 118459 312770C Description VALVE, ball, 3/4 FITTING, nipple, hex STRAINER, y SCREEN, 20 mesh; not shown FITTING, union, swivel, 3/4 in. Qty.
Graco Standard Warranty Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.
