User's Manual

Maintenance

312753E 15

c. While holding the conduit (DB) stationary,

tighten the adapter (DC) by hand until it con-

tacts the jam nut (DD).

d. Remove the sensor gauge (DG) from the sen-

sor cap (DH).

e. This step will ensure a clearance of

0.010-0.015 in. (0.254-0.381 mm) between the

material plunger (DF) and proximity switch (DA).

8. Reinstall the cover plate to the material plunger

housing/sensor cap using the two M4 flat head

screws.

9. Connect the proximity switch to the machine at the

Amphenol connector.

Key:

CA Proximity Switch

CB Conduit

CC Adapter

CD Lock-washer

CE 8 mm Jam Nut

CF Sensor Gauge M1978-1

CG Material Plunger

CH Material Plunger Cylinder Housing

FIG. 4: Material Proximity Switch - Models 5/8, 6/10, 10/14

Set Proximity Switch to make contact here on models 5/8, 6/10, 10/14.

0.010-0.015 in. (0.254-0.381 mm)