User's Manual

Drum Cover Installation

312738C 3

Drum Cover Installation

1. HP and HF Models Only: Remove bolts (128) and

shroud (126) from pump.

2. Remove screws (4) and washers (5) from drum

cover (1) (F

IG. 3). Save these parts. They will be

reused to secure the pump to the drum cover for

reassembly.

3. Place drum cover (1) on drum (a). For 120 pound

models only, tighten thumb screws (6) securely)

IG. 3).

4. HP and HF Models Only:

Remove and discard pro-

tective cap (b) from end of pump down tube (208)

IG. 5).

5. Verify gasket (3) is in place on top the drum cover

and laying flat (F

IG. 3, page 3). Install pump down

tube through opening in the center of the gasket (3)

and drum cover (1) and into drum.

FIG. 2

FIG. 3

126

128

247704 and 77X515 - 400 pound models

247703 and 77X514 - 120 pound model

FIG. 4: 120 Pound Cover Shown

FIG. 5

208