User's Manual

22 312307E

Angle Stall Layout: Parking Mode

Establish the center line and outer boundary

PARKING Mode

Press REMOTE SWITCH to START and FINISH dots.

Establish enough reference dots to guide striper for applying stall lines by

using PARKING MODE measuring 18 ft out from centerline.

NOTE: The striper measures moving forward or reverse, as shown, placing

evenly-spaced dots at desired spacing.

ti10117b

START

32 Stalls

START

NOTE: For best results, always dot in the same direction.

NOTE: Minimum RPM for placing dots is 2600.

NOTE: Minimum pressure on LLIV 250SPS is 1000 psi.