User's Manual

Repair
6 311716C
d. Place the o-ring (20*) onto the valve seat (13).
e. Use a 2-1/2 in. hex wrench to install the valve
seat (13) into the displacement rod (1†).
f. Remove the displacement rod assembly from
the vise and set it aside.
3. Place the intake valve housing (18) in a vise.
a. Place the o-ring (21*) around the intake valve
housing (18).
b. Install the valve plate (16*) rounded side up.
c. Install the pin (6†) in the housing (18).
d. Leave the intake valve housing (18) in the vise.
4. Place the cylinder (17†) on the intake valve housing
(18).
5. Lubricate the displacement rod assembly and slide
it into the cylinder (17†).
6. Place the o-ring (21*) on the outlet housing (19). Set
the outlet housing onto the cylinder (17†), aligning
the four holes in the housing with the holes in the
intake housing (18).
7. Place the packing retainer (2) onto the cylinder.
8. Install the tie bolts (4) through the outlet housing
(19). Torque the bolts to 57-64 ft-lb (77-85 N•m).
See pump assembly manual 311833, for further infor-
mation.