User's Manual

Distance Sensor Adjustment
311021U 15
Distance Sensor Adjustment
Gear Alignment
1 Relieve pressure, page 7.
2 Fig. 3. Remove dust cap (142) from wheel. Remove
nut (127).
3 Remove wheel (120) from LineLazer.
4 Align gear (67) with sensor.
a. Pull gear out from wheel with gear puller.
b. Push gear in toward wheel with mallet.
5 Install wheel (120) on LineLazer.
6 Install nut (127) until tight, then back off 1/4 turn.
Install dust cap (142) on wheel.
Sensor Height Adjustment
1 Remove wheel (120) from LineLazer.
2 Remove distance sensor (66).
3 Adjust sensor assembly height with two 17 mm nuts
of sensor so bottom surface of sensor is 0.638 +/-
0.020 from bottom surface of shield. Torque to 8 +/-
2 in-lb.
.638 in.
ti6400a
120
66
67
120142 127
66
Fig. 3
Frame
Inside of tire
Axle
Distance
Sensor
Tire
Gear