User's Manual

ManualsBrandsGraco ManualsDo-It-Yourself tools309923F

Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 USA

309923F

Instructions - Parts List

Air Controls

Air Control Assemblies

Provide clean, dry, regulated compressed air

* Regulator maximum CFM is 50. See table below for maximum filter CFM.

See Air Regulator manual 309924 for additional information on air regulator.

Air Filters

With 5 micron filtration

Important Safety Instructions

Read all warnings and instructions in this manual.

Save these instructions.

Part No. Description

Includes Maximum

Regulated Air

PressureRegulator* Filter*

234398 2 regulated outlets and 1 filtered main

line outlet

234392 similar to

234396,

page 6

160 psi

(1.1 MPa, 11 bar)

234399 2 regulated outlets and 2 filtered main

line outlets with gauge and air cock

234392

234400 2 air regulators, each has 2 regulated

outlets and 1 filtered main line outlet

with gauge and air cock

234392

234411 2 regulated outlets and 1 filtered main

line outlet

234392 234410

Part No. Description Inlet Outlets

Maximum

CFM

Maximum Air Inlet

Pressure

234396 Air Filter, bare 1/2” npt(f) 3/8” npt(f) 120 CFM

175 psi

(1.2 MPa, 12 bar)

234410 Air Filter, bare 1/2” npt(f) 3/8” npt(f)

1/4” npt(f)

plugged

75 CFM

234412 Air Filter, quick

coupler

1/4” npt(f) 1/4” npt(f)

1/4” npt(f)

plugged

75 CFM

Summary of content (8 pages)

PAGE 1
Instructions - Parts List Air Controls 309923F Important Safety Instructions Read all warnings and instructions in this manual. Save these instructions. Air Control Assemblies Provide clean, dry, regulated compressed air Includes Part No.
PAGE 2
Installation Installation CAUTION Do not hang the air control unit directly off a pump air motor inlet, which could be damaged by the weight of the unit and operating stress. Use pipe compound or tape sparingly and only on male threads. Locate the regulator as close as possible to the equipment it serves. Install a main air shutoff valve upstream from the air controls to isolate them for service. Before installing air line components, blow out the pipe line to remove debris.
PAGE 3
Shop Air Piping Layout Minimum Pipe Size Recommendations Compressor Main Air Line HP CFM Length ft (m) Size in. (mm) 1-1/2 - 2 6-9 any 3/4 (19) 3-5 12 - 20 Up to 200 (61) 3/4 (19) Over 200 (61) 1 (25.4) Up to 100 (30.5) 3/4 (19) Over100-200(30.5-61) 1 (25.4) Over 200 (61) 1-1/4 (31.8) Up to 100 (30.5) 3/4 (19) Over100-200(30.5-61) 1-1/4 (31.8) Over 200 (61) 1-1/2 (38.
PAGE 4
Operation Operation Pressure Adjustment Do not exceed the Maximum Incoming Air Pressure of the equipment. Over pressurizing can cause component rupture and serious injury. Turn clockwise to increase air pressure. Turn counterclockwise to decrease air pressure. Pressure Relief Procedure To avoid injury, relieve air and fluid pressure before checking, cleaning, or repairing the equipment. The following is a basic pressure relief procedure.
PAGE 5
Parts Parts Air Control Assemblies Part No. 234398 Part No. 234400 289171 289340 289340 289172 289149 118489 118488 289173 118488 289149 289165 See page 6 289174 Seepage6 289165 234392 234392 See manual 309924 for parts See manual 309924 for parts 289341 Part No. 234411 Part No.
PAGE 6
Parts Air Filters Parts for Bare Filter 234396 and for Filter supplied with Air Controls 234398, 234399, and 234400 289175 Part No.
PAGE 7
Parts 309923F 7
PAGE 8
Graco Standard Warranty Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.