User's Manual

308968 3
WARNING
INJECTION HAZARD
Spray from the applicator, hose leaks, or ruptured components can inject fluid into your body and
cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on
the skin can also cause serious injury.
D Fluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate
medical attention.
D Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
D Follow the Pressure Relief Procedure in your separate equipment manuals whenever you are
instructed to: relieve pressure; stop dispensing; clean, check, or service the equipment; or
install or clean a nozzle.
D Tighten all the fluid connections before operating the equipment.
D Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immedi-
ately. Permanently coupled hoses cannot be repaired; replace the entire hose.
D Always wear eye protection and protective clothing when installing, operating, or servicing this
dispensing equipment.
D Never wipe off build-up around the nozzle or inlet cap until pressure is fully relieved.
FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition
and result in fire or explosion and serious injury.
D Ground the equipment and the object being dispensed.
D Do not use this equipment with flammable liquids.
D Keep the dispense area free of debris, including solvent, rags, and gasoline.
D If there is any static sparking or you feel an electric shock while using the equipment, stop dis-
pensing immediately. Do not use the equipment until you have identified and corrected the
problem.
D Be sure all electrical work is performed by a qualified electrician only.
D Have any checks, installation, or service to electrical equipment performed by a qualified electri-
cian only.
D Be sure all electrical equipment is installed and operated in compliance with applicable codes.
D Be sure power is disconnected when servicing and repairing equipment.
D Before operating the equipment, extinguish all open flames or pilot lights in the dispense area.
D Do not smoke in the dispensing area.
D Keep liquids away from the electrical components
D Disconnect electrical power at the main switch before servicing the equipment.