User's Manual

 
Installation
General
1. Connect the hydraulic motor (101) and the dis -
placement pump (102) as explained on page 8.
See Fig. 1.
CAUTION
Keep the hydraulic system clean
T o reduce the risk of damaging the hydraulic power
supply and motor , blow out all hydraulic lines with air ,
flush thoroughly with solvent, and then blow out with
air again before connecting the lines to the hydraulic
motor.
Always plug the hydraulic inlets, outlets and lines
when disconnecting them for any reason to avoid
introducing dirt and other contaminants into the
system.
Carefully follow the manufacturer ’ s recommendations
on reservoir and filter cleaning, and periodic changes
of hydraulic fluid. The maximum water content of the
hydraulic oil is 1 percent.
Fig. 1
06169
101
102