User's Manual

ManualsBrandsGraco ManualsMixersGraco 308656FHusky/Twistork Package

Table Of Contents

Parts List

Instructions–Parts List

308656F

ENG

Important Safety Instructions

Read all warnings and instructions in this manual.

Save these instructions.

Huskyt/ Twistorkt

Package

Used to mix and transfer fluids in bung–type, 55–gallon (200–liter)

drums. For professional use only.

100 psi (0.69 MPa, 6.9 bar) Maximum Air Input Pressure

Model 238859, Series B

Husky/Twistork package with polypropylene pump

Model 238860, Series B

Husky/Twistork package with acetal pump

Table of Contents

Warnings 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Installation 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Operation 4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Service 5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Parts List 5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Parts Drawing 6. . . . . . . . . . . . . . . . . . . . . . . . . . . .

Technical Data 7. . . . . . . . . . . . . . . . . . . . . . . . . . .

Dimensional Drawing 7. . . . . . . . . . . . . . . . . . . . .

Graco Standard Warranty 8. . . . . . . . . . . . . . . . .

Graco Information 8. . . . . . . . . . . . . . . . . . . . . . . .

06273B

Summary of content (8 pages)

PAGE 1
Instructions–Parts List Huskyt/ Twistorkt Package 308656F ENG Used to mix and transfer fluids in bung–type, 55–gallon (200–liter) drums. For professional use only. 100 psi (0.69 MPa, 6.9 bar) Maximum Air Input Pressure Model 238859, Series B Husky/Twistork package with polypropylene pump Model 238860, Series B Husky/Twistork package with acetal pump Important Safety Instructions Read all warnings and instructions in this manual. Save these instructions. ÂÂ Table of Contents Warnings . . . . . . . . . .
PAGE 2
Symbols Warning Symbol Caution Symbol WARNING CAUTION This symbol alerts you to the possibility of serious injury or death if you do not follow the instructions. This symbol alerts you to the possibility of damage to or destruction of equipment if you do not follow the instructions. WARNING EQUIPMENT MISUSE HAZARD Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury. INSTRUCTIONS D This equipment is for professional use only.
PAGE 3
WARNING FIRE AND EXPLOSION HAZARD Improper grounding, poor ventilation, open flames, or sparks can cause a hazardous condition and result in a fire or explosion and serious injury. D Ground all equipment and the equipment being dispensed to. Refer to Grounding on page 4. D If you are dispensing non-conductive flammable fluids, you must use the unit with the acetal pump, which is conductive.
PAGE 4
Installation NOTE: This unit is shipped with the ground wire attached to the grounding strip on the pump and to the grounding lug on the agitator. The ground wire must always be attached to these two places during use. Grounding WARNING FIRE AND EXPLOSION HAZARD This unit must be grounded. Before you operate it, ground the system as explained in this section. Also, read Fire and Explosion Hazard on page 3.
PAGE 5
Service See the individual component instruction manuals for service instructions specific to the agitator and the pump. CAUTION Before operation, tighten the bung connection firmly by hand, and check it periodically during operation for tightness. See the Parts Drawing on page 6. Parts List Husky/Twistork Package, Model 238859, Series B Includes items 1, 3 through 20 Husky/Twistork Package, Model 238860, Series B Includes items 2 through 20 Ref No. 1 Part No.
PAGE 6
Parts Drawing 9 1 1, 2 18 grounding strip 17 16 20 A 4 12 15 5 grounding lug 14 8 20 7 19 6 13 A Â Â 5 11 10 1 2 3 6 10 2 4 bung connection agitator needle valve Husky 515 Diaphragm Pump (see manual 308981) Twistork Agitator (see manual 308345) Twistork agitator shown is Model 236629, except for the following parts differences: 112572, SWIVEL, union; 90_ Removed for Husky/Twistork. 189648, COVER, belt drive Husky/Twistork bracket (5) includes belt drive cover.
PAGE 7
Technical Data Maximum air input pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 psi (7 bar) Maximum fluid output pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 psi (7 bar) Maximum siphon flow rate with 100 cps material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 gpm (45.4 lpm) with 1000 cps material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 8
Graco Standard Warranty Graco warrants all equipment manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.