User's Manual

307623H 7
Installation
Fig. 2
C
P
D
R
E
F
H
J
L
G
Q
M
A
N
B
3/4 npt(m)
FLUID INLET
K
HYDRAULIC INLET
3/4 UNF–2A 37_ (M) FLARE
HYDRAULIC OUTLET
7/8-14 UNF-2A 37 (M) FLARE
KEY
A Fluid Hose to Gun
B Fluid Drain Valve
C Suction Hose
D Hydraulic Return Line
E Supply Line Shutoff Valve
F Pressure Gauge
G Flow Control Valve
H Pressure Reducing Valve
J Accumulator
K Drain Line
L Hydraulic Supply Line
M Hydraulic Power Supply
N Ground Wire
P Wet cup
Q Check Valve
R Return Line Shutoff Valve
Hydraulic Lines
Supply Line (L): Connect a 1/2 in. minimum ID to the
3/4–16 UNF–2a, 37 male flare inlet of the reciproca-
tor.
Return line (D): Connect a 5/8 in. minimum ID to the
7/8–14 UNF–2a, 37 male flare outlet of the reciproca-
tor.
On the hydraulic supply line (L), install the following
accessories:
 A shutoff valve (E) to isolate the system for servic-
ing.
 A fluid pressure gauge (F) to monitor the hydraulic
oil pressure to the reciprocator and avoid overpres-
surizing the reciprocator or displacement pump
 A pressure- and temperature-compensated flow
control valve (G) to prevent the reciprocator from
running too fast.
 A pressure-reducing valve (H) with a drain line (K)
running directly into the hydraulic return line.
 An accumulator (J) to reduce the hammering effect
caused by the reciprocator reversing direction.
On the hydraulic return line (D), install a shutoff valve
(R) for isolating the reciprocator for servicing.
WARNING
To reduce the risk of serious bodily injury, including
fluid injection, your system must include a drain
valve installed near the pump fluid outlet to help
relieve fluid pressure in the displacement pump and
hoses when shutting off the pump. See Fig. 2.
Install a fluid drain valve (B) and a grounded dispense
hose (A) to the 3/8 npt fluid outlet on the displacement
pump. Connect a suction hose to the 3/4 npt pump
fluid intake. See Fig. 2.