Full Product Manual
Table Of Contents
- Models
- Important User Information
- Contents
- Safety Symbols
- General Warnings
- Know Your Sprayer
- Know Your Controls
- Driver Installation
- Setup
- Startup
- Spraying
- Cleanup
- Storage
- Recycling and Disposal
- Troubleshooting
- Replacement Parts
- Technical Specifications
- California Proposition 65
- Notes
- Graco Standard Warranty
- Graco Information
Cleanup
22 3A9402A
Cleanup
Cleaning Sprayer
Cleaning your sprayer properly and after
every spray job is of the utmost importance!
Proper care and maintenance will make your
paint sprayer last and work for you trouble
free.
1. Turn Prime Knob down to PRIME
position to relieve system pressure.
2. Remove cup assembly from sprayer,
and remove Pump Filter. Set sprayer on
a rag.
3. Remove Cup Lid and pour extra paint
back into paint can. Clean all parts with
warm water.
NOTE: Be sure to clean inside the VacuValve
reservoir. If the VacuValve air hole becomes
clogged, use a paper clip to clean hole.
Use only water-based materials to
prevent serious injury from fire and
explosion.
NOTICE
To avoid damage to equipment, do not
expose the driver electronics to cleaning
fluids. Keep sprayer at least 10 in. (25 cm)
above the rim of the container when
cleaning.