Full Product Manual
Table Of Contents
- Models
- Important User Information
- Contents
- Safety Symbols
- General Warnings
- Know Your Sprayer
- Know Your Controls
- Driver Installation
- Setup
- Startup
- Spraying
- Cleanup
- Storage
- Recycling and Disposal
- Troubleshooting
- Replacement Parts
- Technical Specifications
- California Proposition 65
- Notes
- Graco Standard Warranty
- Graco Information
Startup
3A9402A 15
Startup
1. Install the cup onto the sprayer as
follows:
a. Verify Pump Filter is installed and
clean.
b. Align VacuValve (on Cup Lid) with
Prime Knob (on sprayer).
c. Push cup assembly onto the
sprayer, twist to lock.
2. Prime the pump as follows:
a. Verify Prime Knob is pointed down
to PRIME position.
b. Open the VacuValve cap and
gently squeeze the FlexLiner until
no more air bubbles appear in the
VacuValve.
NOTE: Tilt the sprayer such that the
VacuValve is the highest point so that all air
in the FlexLiner can be fully evacuated.