Full Product Manual
Table Of Contents
- Models
- Important User Information
- Contents
- Safety Symbols
- General Warnings
- Know Your Sprayer
- Know Your Controls
- Driver Installation
- Setup
- Startup
- Spraying
- Cleanup
- Storage
- Recycling and Disposal
- Troubleshooting
- Replacement Parts
- Technical Specifications
- California Proposition 65
- Notes
- Graco Standard Warranty
- Graco Information
Setup
12 3A9402A
Setup
Pressure Relief Procedure
Follow the Pressure Relief
Procedure whenever you see this
symbol.
1. Turn Prime Knob down to PRIME
position to relieve pressure.
Cup Fill
1. Insert one FlexLiner into the Cup
Support.
NOTE: Verify there is no damage to the top
sealing edge of the FlexLiner, such as a
crease or fold. If damaged it will leak air and
lose prime.
This sprayer builds up an internal
pressure of 2000 psi (138 bar, 13.8 MPa)
during use. To prevent serious injury from
skin injection, follow this Pressure Relief
Procedure whenever you stop spraying
and before cleaning, checking, servicing,
or transporting equipment.
Use only water-based materials to
prevent serious injury from fire and
explosion.