Full Product Manual
Table Of Contents
- Before You Spray
- Contents
- Important Grounding Information
- Warnings
- Know Your Sprayer
- Know Your Controls
- Grounding Instructions
- Setup
- Start Up
- Spraying
- Cleanup
- Storage
- Reference
- Maintenance
- Troubleshooting
- ProX19 Cordless Cart Sprayer Parts
- ProXChange Pump Parts
- Wiring Diagram - 60VDC
- Technical Specifications
- California Proposition 65
- Graco Standard Warranty
- Graco Information
Spraying
20 3A9019C EN
Spraying
Start
1. Turn pressure control knob to START
position. When spraying oil-based or
flammable materials, follow Grounding
Instructions, page 11.
2. Disengage trigger lock.
Adjust Pressure Control
To select a setting, align symbol on pressure control knob with setting indicator on sprayer.
1. For best spray results with lowest overspray, adjust pressure control to “START” setting.
2. Test the spray pattern on a test area or piece of cardboard.
3. If needed, increase Pressure Control Knob setting to minimum setting that results in an acceptable
spray pattern.
Spray Pattern Quality
A good spray pattern is evenly distributed as it hits
the surface.
• Spray should be atomized (evenly
distributed, no gaps at edges).
• Increase Pressure Control Knob setting if
needed until spray is even and without gaps
at edges.
• Spray Tip may be worn or a smaller tip may
be needed. See Spray Tip and Pressure
Selection, page 22.
• Material may need to be thinned. If material
needs to be thinned follow manufacturer’s
recommendations.