Full Product Manual
Table Of Contents
- Table of Contents
- Models
- Warnings
- Component Identification
- Component Identification
- Component Identification
- Preparation
- Setup
- Operation (Pressurized Hopper Gun)
- Cleanup
- Troubleshooting
- Parts - Air Compressor (Series A)
- Parts List - Air Compressor (Series A)
- Parts - Air Compressor (Series B)
- Parts List - Air Compressor (Series B)
- Parts - Air Compressor (cont.)
- Parts List - Air Compressor (cont.)
- Parts - Air Compressor
- Parts List - Air Compressor
- Parts - Pressurized Hopper 25D496
- Parts List- Pressurized Hopper 25D496
- Parts - Pressurized Gun 25D496
- Parts List - Pressurized Gun 25D496
- Parts - Gravity-Fed Hopper Gun 25D497
- Parts List - Gravity-Fed Hopper Gun 25D497
- Wiring Diagram
- Air Diagram
- Technical Specifications
- Graco Standard Warranty
- Graco Information
Warnings
3A5725D 5
ELECTRIC SHOCK HAZARD
This equipment must be grounded. Improper grounding, setup, or usage of the system can
cause electric shock.
• Turn off and disconnect power cord before servicing equipment.
• Connect only to grounded electrical outlets.
• Use only 3-wire extension cords.
• Ensure ground prongs are intact on power and extension cords.
• Do not expose to rain. Store indoors.
PRESSURIZED EQUIPMENT HAZARD
Fluid from the equipment, leaks, or ruptured components can splash in the eyes or on skin and
cause serious injury.
• Follow the Pressure Relief Procedure when you stop spraying/dispensing and before
cleaning, checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
• Always wear appropriate gloves, eye protection, and a respirator or mask when spraying.
• Do not operate or spray near children. Keep children away from equipment at all times.
• Do not overreach or stand on an unstable support. Keep effective footing and balance at
all times.
• Stay alert and watch what you are doing.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not kink or over-bend the hose.
• Do not expose the hose to temperatures or to pressures in excess of those specified by
Graco.
• Do not use the hose as a strength member to pull or lift the equipment.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
•
Make sure all equipment is rated and approved for the environment in which you are using it.