Full Product Manual
Table Of Contents
- Table of Contents
- Models
- Warnings
- Component Identification
- Component Identification
- Component Identification
- Preparation
- Setup
- Operation (Pressurized Hopper Gun)
- Cleanup
- Troubleshooting
- Parts - Air Compressor (Series A)
- Parts List - Air Compressor (Series A)
- Parts - Air Compressor (Series B)
- Parts List - Air Compressor (Series B)
- Parts - Air Compressor (cont.)
- Parts List - Air Compressor (cont.)
- Parts - Air Compressor
- Parts List - Air Compressor
- Parts - Pressurized Hopper 25D496
- Parts List- Pressurized Hopper 25D496
- Parts - Pressurized Gun 25D496
- Parts List - Pressurized Gun 25D496
- Parts - Gravity-Fed Hopper Gun 25D497
- Parts List - Gravity-Fed Hopper Gun 25D497
- Wiring Diagram
- Air Diagram
- Technical Specifications
- Graco Standard Warranty
- Graco Information
Cleanup
3A5725D 21
7. Remove hopper from gun and finish
cleaning all components. A soft brush
may be used to help loosen any dried
material from the surface.
8. Check air relief valve. If sticky or
contaminated with material,
disassemble and clean. Grease o-rings
and reassemble.
9. Clean
hopper air passageway and air
supply tube.
10. Connect air hose to gun.
11. Turn air compressor ON.
12. Open gun air flow valve to allow air flow
through the needle to clear out
remaining material. Perform Pressure
Relief Procedure, page 10.
13. If trigger feels sticky, lubricate needle
seals.