Full Product Manual

Cleanup
20 3A5725D
Cleanup
Once you finish spraying, follow these steps
to clean your gun and hopper.
1. Perform Pressure Relief Procedure,
page 10.
2. Drain remaining material into a bucket
until most of the texture material is out of
hopper.
3. Fill hopper with clean water.
4. Remove nozzle from gun. Trigger gun
into bucket until most of texture mix is out
of the hopper. Allow water to flow
through gun until gun is clean.
5. Open gun air flow valve, allowing air
through nozzle to clear out any
remaining material.
6. Disconnect spray gun from air hose.