Full Product Manual
Table Of Contents
- Table of Contents
- Models
- Warnings
- Component Identification
- Component Identification
- Component Identification
- Preparation
- Setup
- Operation (Pressurized Hopper Gun)
- Cleanup
- Troubleshooting
- Parts - Air Compressor (Series A)
- Parts List - Air Compressor (Series A)
- Parts - Air Compressor (Series B)
- Parts List - Air Compressor (Series B)
- Parts - Air Compressor (cont.)
- Parts List - Air Compressor (cont.)
- Parts - Air Compressor
- Parts List - Air Compressor
- Parts - Pressurized Hopper 25D496
- Parts List- Pressurized Hopper 25D496
- Parts - Pressurized Gun 25D496
- Parts List - Pressurized Gun 25D496
- Parts - Gravity-Fed Hopper Gun 25D497
- Parts List - Gravity-Fed Hopper Gun 25D497
- Wiring Diagram
- Air Diagram
- Technical Specifications
- Graco Standard Warranty
- Graco Information
Setup
3A5725D 13
6. If using WideTex adapter, install disc (2)
on front of adapter (3) with retaining ring
(1). Install a standard nozzle (4) on front
of gun with the assembly. Pulling trigger
when installing nozzle makes assembly
easier. If desired finish is not achieved,
try a different size standard nozzle. See
Recommended Nozzle & Disc
Selection Charts, page 19.
7. Plug power cord into a properly
grounded outlet.
Material Hopper
When spraying ceilings, the hopper should
be tilted forward. When spraying floors, the
hopper should be tilted backward. Doing so
aids in emptying more texture from the
hopper.
Install Hopper
1. Apply grease to o-ring to make hopper
easier to attach to the gun.