User Manual

ManualsBrandsGraco ManualsPaint180 Degree Easy Turn Directional Spray Nozzle

308244C

Instructions - Parts List

180° Spray Nozzle Adapter

For professional use only.

3600 psi (24.8 MPa, 248 bar) Maximum Working Pressure

Model 235486

For use on any Graco high pressure gun or extension and with the

RAC

IV, RAC

5, and RAC X™ DripLess™ Tip Guard or a Standard

flat tip guard.

Important Safety Instructions

Read all warnings and instructions in this manual. Be familiar

with the controls and the proper usage of the equipment.

Save these instructions.

ti26835a

Ref. Part Description Qty.

1 166969 GASKET, non-metallic 1

2 NOZZLE, spray angle 180° 1

Summary of content (4 pages)

PAGE 1
Instructions - Parts List 308244C 180° Spray Nozzle Adapter EN For professional use only. Important Safety Instructions Read all warnings and instructions in this manual. Be familiar with the controls and the proper usage of the equipment. Save these instructions. 3600 psi (24.8 MPa, 248 bar) Maximum Working Pressure Model 235486 For use on any Graco high pressure gun or extension and with the RAC® IV, RAC® 5, and RAC X™ DripLess™ Tip Guard or a Standard flat tip guard. 1 2 ti26835a Ref.
PAGE 2
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
PAGE 3
Service Service Pressure Relief Procedure Installation Follow the Pressure Relief Procedure whenever you see this symbol. This equipment stays pressurized until pressure is manually relieved. To help prevent serious injury from pressurized fluid, such as skin injection, splashing fluid and moving parts, follow the Pressure Relief Procedure when you stop spraying and before cleaning, checking, or servicing the equipment. 1. Install the adapter on the gun as shown, but do not install a spray tip yet.
PAGE 4
Graco Standard Warranty Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.