Installation Guide

9 Vehicle

Information

Lap/Shoulder Belt Installation

How to Lock Your Lap and Shoulder Vehicle Seat Belt

Sliding Latch Plate and Switchable Retractor

A latchplate that slides freely on the belt webbing and cannot, by

itself, hold the belt snug around a car seat.

When installing the car seat, route the vehicle seat belt through

the proper belt path and buckle it in. Slowly pull the shoulder

belt all the way out to switch it to locking mode. Then, as

you pull the vehicle seat belt tight, feed all the slack back into the

retractor.

Grab the sides of the seat at the belt path and slide the seat side-

to-side and front-to-back. The seat should not move more than 1”

(2.5 cm).

Note: if using the lock-off, you do not need to switch the retractor.