Installation Guide

8 Moving
LATCH
90
LATCH
To remove the InRight
TM
LATCH connectors from the lower
anchors, push in on the red buttons and pull them off.
Top Tether Strap
To remove, lift up on the tether lock to release the tension.
Press in on the hook’s spring. Push tether hook in, then lift up
and pull away from tether anchor.
3. Move the LATCH strap
Slide the LATCH belt and connectors down along the grey bar
to the rear-facing belt path.
4. Route the LATCH Strap
Route the LATCH strap through the rear-facing belt path.
Make sure the strap is flat and not twisted.
5. Store the LATCH Straps
From the bottom of the seat, open the LATCH storage door
and slide the InRight
TM
LATCH connectors into the storage
locations. Remove the slack from the strap.