Installation Guide

3 Rear

Facing

3-A Rear-Facing Use

LATCH Strap

Vehicle Lap/Shoulder

Seat Belt

Rear-Facing:

5-40 lb (2.3-18 kg)

• Car seat must be rear-facing in the vehicle back seat.

• Make sure LATCH strap or vehicle seat belt is routed through the

rear-facing belt path, marked with a blue label.

• Install this car seat tightly in your vehicle. Car seat should not

move at the rear-facing belt path more than 1” (2.5 cm) from side-

to-side and front-to-back.

• Check the rear-facing level indicator to make sure the car seat is

level with the ground.

• Harness straps must be at or just below the top of child’s

shoulders and chest clip must be at armpit level.

• Infants who weigh less than 22 lb (10 kg) MUST be rear-

facing.

• DO NOT adjust On The Go

Recline when vehicle is moving.

Recline should only be changed when car is fully stopped

and in a parked position.

• Make sure the recline foot is in the rear-facing position.

*Check your state laws and the AAP/NHTSA recommendations.

*Do not install by this

method for a child

weighing more than 35 lb

(16 kg)