Operating Guide
Table Of Contents
- Models
- Warnings
- Component Identification
- Preparation
- Setup
- Mixing Material
- Operation
- Shutdown and Cleanup
- Maintenance
- Troubleshooting
- RTX1400si Sprayer
- RTX2000pi Sprayer
- RTX2500pi Sprayer
- Notes
- Compressor Parts
- Flow Switch Assembly
- Gun & Hose
- Wiring Diagrams
- Wiring Diagram
- Technical Specifications
- Graco Standard Warranty
- Graco Information
Shutdown and Cleanup
3A3258L 17
Shutdown and Cleanup
NOTE: Keep pump and hose clean when
switching between simulated acoustic,
knockdown and orange peel applications. A
dirty pump can release particles of texture
into the finish.
• To increase pump life, life turn power
OFF when not spraying.
• Before removing material hose, perform
Pressure Relief Procedure, page 9.
Make certain there is no material in the
hose.
• To keep sprayer in good operating
condition, always clean it throughly and
prepare it properly for storage.
When you have finished spraying:
1. Open gun air valve.
2. Turn ON/OFF switch to ON position.
3. Close gun air valve.
4. Trigger gun into bucket until most of
texture mix is pumped out.
5. Fill material hopper with 2-4 gallons of
clean water.
ti27341a
ti27380a
ti27383a
ti27381a
ti27346a