Installation Guide

Shutdown and Cleanup
3A3373C 9
Shutdown and Cleanup
NOTE: Keep pump and hose clean when
switching between materials. A dirty pump
can release particles of texture into the finish.
When you have finished spraying:
1. Drain remaining material into bucket
until most of texture material is out of
the hopper.
2. Fill material hopper with clean water.
3. Remove nozzle from gun. Trigger gun
into bucket until most of texture mix is
pumped out. Allow water to flow through
gun until gun is clean.
4. Finish cleaning all components. A soft
brush may be used to help loosen any
dried on material from surface.
NOTE: Cleaning out all air passages
and components will improve gun per-
formance and life.
5. Connect air line to gun. Open gun air
control valve, forcing air through nozzle
to clear out any remaining material.
6. Disconnect air line and material hose
from gun.
To ensure proper gun function for future use,
remove and clean needle components and
apply a few drops of light oil to:
• air hose quick connect
• material hose connections
• air shutoff needle material needle
NOTICE
Before removing material hose be sure
pressure is relieved and material is not in the
hose.
To keep sprayer in good operating condition,
always clean it throughly and prepare it
properly for storage.
ti28088a
ti28086a
4
5
ti28089a