Instructions / Assembly

ManualsBrandsGraco ManualsPaintProX21 Stand Airless Paint Sprayer

SETUP

START UP – FLUSHING

Connect hose to gun. Remove

red cap, connect hose to sprayer.

Securely tighten.

Read Owner’s Manual for complete

instructions and warnings.

This quick guide is not a substitute for reading

and understanding all instruction manuals and

warning labels supplied with the equipment.

Manuals are available at magnum.graco.com

Follow pressure

relief procedure and wear

protective equipment

including but not limited to

protective eye wear.

SKIN INJECTION

HAZARD: Keep clear

of spray tip and leaks.

Engage trigger lock

when not spraying.

FIRE AND EXPLOSION

HAZARD: Follow

ﬁ re and explosion

warnings as listed in

your manual.

Turn Power Switch

OFF

and plug

sprayer into grounded outlet.

Turn gun trigger lock to locked

position. Unthread spray tip

and guard assembly.

Separate small, clear drain tube

from large suction tube and place

into waste pail.

Turn Pressure Control Knob

to lowest setting.

Allow ﬂ uid to ﬂ ow out drain tube

for 30-60 seconds. Turn Power

Switch

OFF

With the Prime/Spray Valve down to

PRIME

, press PushPrime

™

button twice,

turn Pressure Control Knob to Prime/Clean setting. Turn Power Switch

QUICK GUIDE

Submerge suction tube in water

if spraying water-based material

or ﬂ ushing ﬂ uid if spraying

oil-based.

FAILURE TO FOLLOW ALL WARNINGS CAN RESULT IN SERIOUS INJURY, AMPUTATION, OR DEATH.

Summary of content (4 pages)

PAGE 1
QUICK GUIDE Read Owner’s Manual for complete instructions and warnings. This quick guide is not a substitute for reading and understanding all instruction manuals and warning labels supplied with the equipment. Manuals are available at magnum.graco.com Follow pressure relief procedure and wear protective equipment including but not limited to protective eye wear. SKIN INJECTION HAZARD: Keep clear of spray tip and leaks. Engage trigger lock when not spraying.
PAGE 2
START UP – FILL PUMP, GUN & HOSE WITH PAINT 1 Submerge suction tube in paint. Turn Power Switch ON and wait to see paint coming into the drain tube. Turn Power Switch OFF. 2 Trigger gun into waste pail, turn Prime/Spray Valve forward to SPRAY and turn Power Switch ON. 3 When paint comes out of the gun, release trigger. Turn gun trigger lock to locked position. Thread spray tip and guard assembly to gun. 4 Attach drain tube to suction tube and turn Pressure Control Knob to Spray Setting.
PAGE 3
CLEAN UP: WATER-BASED PAINTS (see Owner’s Manual for oil-based paints) 1 Turn Power Switch OFF. Place suction and drain tubes in waste pail. Turn Prime/Spray Valve down to PRIME. Turn Pressure Control Knob to Prime/Clean setting. Trigger gun into waste pail. 2 With the trigger lock in locked position, unthread spray tip and guard assembly from gun. Place in waste pail for further cleaning. 4 Unscrew inlet strainer from suction tube and place in waste pail for cleaning.
PAGE 4
STORAGE FLUID Power Flush attachment from suction tube. 1 Remove Submerge suction tube in Pump Armor.™ 2 Turn Prime/Spray Valve down to PRIME. Turn Power 3 When Pump Armor comes out of drain tube, 4 Turn Prime/Spray Valve to SPRAY and install inlet turn Pressure Control Knob to lowest setting and Power Switch OFF. Switch ON. Turn Pressure Control Knob to Prime/Clean setting. strainer on suction tube for storage. Every Graco purchase comes with A+ Customer Service.