Troubleshooting Guide

Important Safety Information
4 333394L
Important Safety Information
The following warnings are for the setup, use, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to
procedure-specific risks. When these symbols appear in the body of this manual or on warning
labels, refer back to these Warnings. Product-specific hazard symbols and warnings not
covered in this section may appear throughout the body of this manual where applicable.
WARNING
GROUNDING INSTRUCTIONS
This product must be grounded. In the
event of an electrical short circuit,
grounding reduces the risk of electric
shock by providing an escape wire for
the electric current. This product is
equipped with a cord having a
grounding wire with an appropriate
grounding plug. The plug must be
plugged into an outlet that is properly
installed and grounded in accordance
with all local codes and ordinances.
• Improper installation of the grounding plug
is able to result in a risk of electric shock.
• When repair or replacement of the cord or
plug is required, do not connect the
grounding wire to either flat blade terminal.
• The wire with insulation having an outer
surface that is green with or without yellow
stripes is the grounding wire.
• Check with a qualified electrician or
serviceman when the grounding
instructions are not completely understood,
or when in doubt as to whether the product
is properly grounded.
• Do not modify the plug provided; if it does
not fit the outlet, have the proper outlet
installed by a qualified electrician.
• This product is for use on a nominal 120V
circuit and has a grounding plug similar to
the plug illustrated in the figures.
• Only connect the product to an outlet having
the same configuration as the plug.
• Do not use an adapter with this product.
ti3509b
WARNING
Extension Cords:
•
Use only a 3-wire extension cord
that has a grounding plug and a
grounding receptacle that accepts
the plug on the product.
• An undersized cord results in a
drop in line voltage and loss of
power and overheating.When in
doubt use the next heavier gauge.
The smaller the gauge number the
heavier the cord.
• When using the sprayer outdoors, use an
extension cord suitable for outdoor use.
• Make sure your extension cord is not
damaged. When using an extension cord, be
sure to use a cord heavy enough to carry the
current that your sprayer draws. See chart for
appropriate sizes and lengths:
Extension Cord
Conductor Size Length
AWG (American
Wire Gauge)
Metric Maximum
18
1.0 mm
2
50 ft (15 m)
16
1.5 mm
2
100 ft (30 m)
14
2.5 mm
2
200 ft (61 m)