Installation & Assembly

Step 2
Step 3
Stand the Table up.
If the Table wobbles, adjust the Pre-installed Levellers at the bottom of the Legs until
the Table is level.
This Table can only be used on a flat, level surface.
Make sure all parts are connected and securely locked into position.
Your Table is ready for use.
Step 1
Hardware Used
①：M8 Screw
②：Spring Washer
③：Flat Washer
④：Allen key
⑤：Iron Plate
Position the bottom of the Table top(A) as shown.
And then insert the Legs(B) into the mounting position of Table Top(A).
Attach the Legs(B) by using M8 Screw(1) + Spring Washer(2) + Flat Washer (3) +
Iron Plate (5), onto metal plate of Legs(B), with Allen Key(4).
Do not over tighten Screws(1) while assembling the Legs(B) in order to adjust the
Legs(B) as needed while assembling and make sure you follow the steps fully.
Page 3 OF 4