Caution : You must read this before you proceed Chair Label Picture Description QTY A Chair Seat 1 B Front leg 1 C Backrest 1 Page 1 OF 6
Label Picture Description QTY ① Screw (M4*25mm) 9 ② Screw (M4*20mm) 3 ③ Screw (M4*30mm) 3 ④ Bolt (M6*45mm) 3 ⑤ Bolt (M6*18mm) 3 ⑥ Screwdriver 1 Before Beginning Assembly: Page 2 OF 6
Overview Backrest (C) Seat (A) Front leg (B) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 ⑥ ⑥ Open the carton and place all the parts onto a clean, non-marring surface. Place the Chair Seat(A) with its bottom facing skywards. 1.
Step 2 ⑥ 3 ⑥ 1 4 ⑥ 5 2.1) Attach Backrest(C) to Chair Seat(A) using Screws(③) with Screwdriver(⑥) as shown above 2.2) Attach Backrest(C) to Chair Seat(A) using Screws(①) with Screwdriver(⑥) as shown above. 2.3) Attach Backrest(C) to Chair Seat(A) using Bolts(④) and Bolts(⑤) with Screwdriver(⑥) as shown above. Do not fully tighten the Screws and Bolts.
Step 3 Stand the Chair up. Place the Chair on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected. Gently and gracefully, sit into to the Chair. This will help to align all parts at all joints. Then get off the Chair, and in a sequential manner, proceed to tighten all Screws and Bolts. When tightening the Screws and Bolts, tighten sequentially. DO NOT tighten any Screw and Bolt fully and then move on to the next one. This may cause the frame to warp.
Page 6 OF 6
