Remove drawers. 1. Place the table top (#1) face down onto a protected surface. 2. Prepare 6 bolt assemblies by first inserting a lock washer (#B) onto the bolt (#A) then a flat washer (#C) onto that same bolt (#A). 3. Align the legs (#3) to the corner holes, then insert 2 bolts into each corner. Secure using the Allen wrench (#D).
1. Prepare 3 bolt assemblies by first inserting a lock washer (#B) onto the bolt (#A) then a flat washer (#C) onto that same bolt (#A). 2. Align the shelf (#2) to the holes along the ends of three legs (#3). 1. Prepare 3 bolt assemblies by first inserting a lock washer (#B) onto the bolt (#A) then a flat washer (#C) onto that same bolt (#A). 3. Insert the support leg (#4) into the center hole and turn right to tighten. Adjust according to ground level. 2.
Insert drawers. 1. Drill a hole along the wall slightly smaller than the long screw, then align a bracket to the hole and insert a long screw, secure. 2. After that align the other bracket to the back of the assembly and insert a small screw. Secure using a screwdriver. 3. Secure the strap accordingly.
