Installation & Assembly

ManualsBrandsGracie Oaks ManualsOutdoor & Patio FurnitureArend Outdoor Rocking Chair with Cushions

Caution : You must read this before you proceed

CAUTION : This Chair is NOT a TOY. Keep your child / children at bay in the process of

assembly.

For turning the chair and to prevent damage to the Table, 02 persons may be needed to execute this

action

ROCKING CHAIR

1 o

f 7

Please look in the Seat Panel for hardware packs.

Summary of content (7 pages)

PAGE 1
Caution : You must read this before you proceed Please look in the Seat Panel for hardware packs. ROCKING CHAIR CAUTION : This Chair is NOT a TOY. Keep your child / children at bay in the process of assembly.
PAGE 2
Label Description QTY A Left Arm with Leg Panel 1 B Right Arm with Leg Panel 1 C Backrest Panel 1 D Seat Panel 1 E Seat Cushion 1 F Back Cushion 1 Description Qty ① Long Screw M6x80mm 3 ② Medium Screw M6x60mm 3 ③ Short Screw M6x35mm 5 ④ Short Bolts M6x55mm 3 ⑤ Long Bolts M6x95mm 3 ⑥ Sleeve Nut M6x15mm 5 ⑦ Allen Key 2 No.
PAGE 3
Before Beginning Assembly: OVERVIEW Back Cushion (F) Backrest Panel (C) Right Leg Panel (B) Seat Cushion(E) Left Leg Panel (A) Seat Panel (D) FRONT FACING This Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Chair, the above picture is to help you put the various parts into perspective. Please read through the instructions here below to familiarise the parts and steps before assembly.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 2.1 2.2 B A 2.1) Position Seat Panel (D) to Left Leg Panel (A) Then position Right Leg Panel (B) onto Seat Panel (D) as shown in picture above 2.2) Secure Right Leg Panel (B) to Seat Panel (D) by using Screw (①) , ( ②) and Allen Key (⑦) Then, secure Seat Panel (D) to Left Leg (A) by using Screw ③ and Allen Key (⑦). Do not fully tighten the Screws.
PAGE 5
Step 3 With assistance from your adult partners, turn the Chair into the other side. Repeat the same process of step 2 to secure Left Leg Panel (A) with Seat Panel (D) by using Screw (①),(②), and Allen Key (⑦). Then secure Seat Panel (D) to Right Leg Panel (B) by using Screw (③) and Allen Key (⑦). Do not fully tighten the Screws. Step 4 Turn the Chair right side up.
PAGE 6
Step 5 Turn the Chair right side up. Position Backrest Panel (C) to Leg Panels (A & B) as the picture above Secure Leg Panels (A), (B) to Backrest Panel (C) by using Short Bolts (④), & Sleeve Nuts (⑥) and Allen Key (⑦) Do not fully tighten the Screws. Step 6 Inspect the Chair and make sure all parts are connected. Place Back Cushion (F) and Seat Cushion (E) onto the Chair Tie the velcro straps of Back Cushion (F) to Backrest Panel (C) and Seat Cushion (E) to Seat Panel (D). Your Chair is ready for use.
PAGE 7
of 7