Caution : You must read this before you proceed CHAIR CAUTION: This Chair is NOT a TOY.
A Backrest Panel 1 B Seat Panel 1 Description QTY Label Picture ① Bolts (M6x40mm) 5 ② Flat Washers 5 ③ Allen key 1 Before Beginning Assembly: Page 2 OF 7
Overview This Chair has multiple parts and may require up to some 15 minutes to assemble. To give you an overview of the chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Unpack and place all parts on a clean, non-marring surface Step 2 Position Backrest Panel (A) to the Seat Panel (B) as shown in picture above. Then affix Backrest Panel (A) with Seat Panel (B) by using Bolt (①) , Flat Washers (②) and Allen Key (③).
Step 3 Place the Chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Chair to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the Chair freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles found, proceed to tighten all the Bolts.
Step 4 The Chair is ready to use now.
Questions & Answers about Proposition 65 • What is Proposition 65? Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or that are released into the environment.
