Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench % } assembling a specific product (with 1 being (Included) easy and 5 being difficult). For some ) products, two persons are recommended.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the craw or bolt. Some furniture comes with height adjustment knobs underneath each leg.
I\ Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. /.
1. Prepare 6 bolt assemblies by first inserting a lock washer (#F) onto the bolt (#C) then a flat washer (#E) onto that same bolt 2. Align the legs (#2) to the holes along the back of the headboard then insert 3 bolt assemblies into each leg and secure.
Align the drawer slat support (#6) to the hole along the bottom of the drawer slat then insert the threaded end of the support stopper (#13) into that same hole from above. Turn right to tighten and make sure both supports are firmly secured. #13 Place the ends of the drawer slat {#5) onto the slots along the rails, then insert 2 screws (#B) into each end. Secure using a screwdriver.
Align the end of the runners to the slat then insert a screw (#A) into each end. Secure using a screwdriver. 1. Use screwdriver to remove the screws & handle. > 2. Position the handle in front of drawer panel and screw it tightly with the same screw.
slat (#10) to the holes along the e the slats (#7) onto the rails, then align e cent those slats {#7) and the slat u #9). Insert a bolt from above @ = c #D x PCs insert a screwdriver. ing a acre Place the bed slats (#8) onto the rails, then i screw (#B) into each end.
