1. Prepare 6 bolt assemblies by first inserting a lock washer (#F) onto the bolt (#C) then a flat washer (#E) onto that same bolt (#C). 2. Align the legs (#2) to the holes along the back of the headboard (#1), then insert 3 bolt assemblies into each leg and secure. Hook each end of the side rails (#4) onto the bolts along the headboard (#1) and footboard (#3), then tighten the bolts using the Allen wrench (#H).
Align the drawer slat support (#6) to the hole along the bottom of the drawer slat (#5), then insert the threaded end of the support stopper (#13) into that same hole from above. Turn right to tighten and make sure both supports are firmly secured. Adjust according to the ground level. Place the ends of the drawer slat (#5) onto the slots along the rails, then insert 2 screws (#B) into each end. Secure using a screwdriver.
Align the end of the runners to the slat (#5), then insert a screw (#A) into each end. Secure using a screwdriver. Place the slats (#7) onto the rails, then align the center slat (#10) to the holes along the bottom of those slats (#7) and the slat supports (#9). Insert a bolt (#D) from above and secure.
Place the bed slats (#8) onto the rails, then insert a screw (#B) into each end. Secure using a screwdriver. Place the slat cover (#12), then insert the screws (#A) and secure using a screwdriver.
