Installation & Assembly (Chair)

ManualsBrandsGracie Oaks Manuals3-4 Person Patio Conversation SetsFriedlaender 4 - Person Seating Group with Cushions

Caution: You must read this before you proceed

Assembly Instructions

Caution: This Chair is NOT a TOY.

Keep your child/children at bay during the assembly process.

Whenever lifting or moving the Chair and to prevent damage to the Chair,

two adults may be needed to execute these actions.

Chair

3OHDVHORRNLQWKH6HDW3DQHOIRUKDUGZDUHSDFNV

1 of 6

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed 3OHDVH ORRN LQ WKH 6HDW 3DQHO IRU KDUGZDUH SDFNV Chair Caution: This Chair is NOT a TOY. Keep your child/children at bay during the assembly process. Whenever lifting or moving the Chair and to prevent damage to the Chair, two adults may be needed to execute these actions.
PAGE 2
Part List Label Picture Description Qty A Backrest Panel 1 B Left Arm Panel (with Pre-installed Levellers) 1 C Right Arm Panel (with Pre-installed Levellers) 1 D Seat Panel 1 E Support Bar 1 F Seat Cushion 1 G Back Cushion 1 Description Qty Hardware No.
PAGE 3
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview Back Cushion (G) Right Arm Panel (C) Backrest Panel (A) Seat Cushion (F) Left Arm Panel (B) Seat Panel (D) Support Bar (E) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective.
PAGE 4
Step 2 2.2 2.1 Place the Right Arm Panel(C) facedown onto a clean, non-marring surface. 2.1) Insert the dowels of Support Bar(E) into the mountings in the Right Arm Panel(C). Attach Support Bar(E) to Right Arm Panel(C) using Bolt(①) with Allen Key(③). 2.2) Attach Backrest Panel(A) to Right Arm Panel(C) using Bolts(①) with Allen Key(③). Do not fully tighten the Bolts. Step 3 3.2 3.1 Place the Left Arm Panel(B) facedown onto a clean, non-marring surface. 3.
PAGE 5
Step 4 Attach Seat Panel(D) to the Chair using Screws(②) and Allen Key(③). Note: Insert Screws(②) from inside to outside of Seat Panel(D). Do not fully tighten the Screws. Step 5 Adjust Pre-installed Levellers height for balance Inspect the Chair and make sure all parts are adequately connected. Carefully sit onto the Chair. This pressure will help align all parts at all joints. In a sequential manner, tighten all Bolts and Screws at all joints.
PAGE 6
Step 6 Place Seat Cushion(F), and Back Cushion(G) onto the Chair, and affix the velcro straps around the Chair as shown above. Your Chair is ready to be used. This Chair can only be used on a flat, level surface.