Assembly Instructions

ManualsBrandsGracie Oaks ManualsOutdoor & Patio FurniturePreston Rectangular 6 - Person 69'' Long Dining Set

Caution: This Table is NOT a TOY

Keep your child/children at bay during the assembly process.

Whenever moving/lifting the Table and to prevent damage to the Table, two adults

are needed to execute these actions.

Caution: You must read this before you proceed

TABLE

Page 1 of 7

Summary of content (7 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed TABLE Caution: This Table is NOT a TOY Keep your child/children at bay during the assembly process. Whenever moving/lifting the Table and to prevent damage to the Table, two adults are needed to execute these actions.
PAGE 2
Parts List Label Picture Description QTY A Table Top 1 B Leg 2 C Leg Support Bar 1 Description QTY ① Bolt (M8x45mm) 9 ② Screw (M6x25mm) 5 ③ Washer 5 ④ Allen Key 1 Hardware Label Picture Page 2 of 7
PAGE 3
Assembly Preparation Before Beginning Assembly: Page 3 of 7
PAGE 4
Assembly Steps Overview Table Top (A) Leg (B) Leg Support Bar (C) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
PAGE 5
Step 2 4 B 1 A Attach the Legs(B) to Table Top(A) using Bolts(①) with Allen Key(④) as pictured. Do not fully tighten the Bolts. Step 3 B C 4 2 3 Align Leg Support Bar(C) between Legs(B) as shown above. You may need to apply a little pressure to the Legs, pushing outwards, to enable the Leg Support Bar(C) to be slotted into position. Attach Leg Support Bar(C) to Legs(B) using Screws(②), and Washers(③) with Allen Key(④). Do not fully tighten the Screws.
PAGE 6
Step 4 Stand the Table up, with assistance from your adult partner. Exert pressure floorwards, onto the Table with both your hands. This pressure will help the Legs and Table Top reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten the Bolts and Screws in a sequential manner, until evenly secured. When tightening the Bolts and Screws tighten sequentially. Do not tighten any Bolt or Screw fully and then move on towards the next one.
PAGE 7
Page 7 of 7