Installation & Assembly

 Page:  ‐3‐/5
1.If the group of parts are not already assembled:
  StepA1:Threadthenipple(F)intothescrewcollarloop(I)untilsnug
  Step A2:Threadtheanother end of nipple (F)into single bar(B)thenplacehexnut(E)andwasher(M)overthetopof
nipple(F).
  StepA3:Tightenthehexnut(E)untiltight.Atthispoint,thesideofsinglebarmarked"GND"mustfacetothescrew
collarloop(I).

2. Make fixture assembly
SeptB1:Unscrewthefinial(S)fromfixturebody(P)thenremovethebottomtrim(R)andlid(Q)
fromfixturebody(E)
SeptB2:Carefullypullthewiresandpushthethreadedendsofarm(O)intofixturebody(P),slidewasheroverthe 
threadedendofarms(O),thensecurewiththenut(E).
Positionlid(Q)andbottomtrim(R)overthenipple(F)inthecenteroffixturebody(P),securewiththefinial(S)
StepB3:carefullypassfirturewiresthroughtubes(M) 
Threadthetubes(M)ontothefixturebody(P)untilsnug,thenthreadtheloop(L)ontothetube(M).





