Installation Instructions

1
Installation Instructions for
1
2
3
4
5
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
Outdoor
1A
JUNCTION BOX
MOUNTING
PLATE
7
8
FIXTURE
SCREW
6
7
8
14
FIXTURE
BASE
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for wet locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
9
10
ANCHOR
ANCHOR
SCREW
11
12
13
3
14
FIXTURE
LAMP
GLASS PANEL
COVER
COVER
SCREW
12
11
13
5
FIXTURE LOOP
FIXTURE
LOOP SCREW
10
11
CLIP
11
Outdoor Wall
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations on the mounting plate and remove the mountingplate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Insert the glass panels into the fixture and secure them in place using the clips.
Install the cover on top of the fixture and secure it using the cover screws.
Install the fixture loop to the top of the cover and secure it in place with the fixture loop screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.