Assembly And Installation Instructions

Turn on the power at fuse or circuit box
8. Place the fitter on the top of the post, and then secure it with fitter screws.
CAUTION: With silicone caulking compound, caulk completely around where
the fitter meets with the post surface to prevent water from seeping into the
post.
9. Turn on the power at the main fuse or circuit breaker box.
1. Turn off the power at fuse or circuit box before starting installation.
2. Unscrew the hex nut and washer to remove the plate from the fixture.
2. Loosen the wire nuts connected with the wires from photocell. (See Fig.1)
Note: Do not move the photocell to prevent water from seeping into the post.
3. Take a white pigtail and black pigtail and make wire connections using wire nuts: (See Fig.2)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the post.
Photocell
White Wires From
Photocell
Wire Nuts
Black Wire From
Fixture
Wires From Fixture
Wires From
Main Power
Wire Nut
White Pigtail
Pigtail
Red Wires From
Photocell
Black Wires From
Photocell
Operation the Unit Without Photocell
Fig.1
Fig.2
White Wire From
Fixture
Hex Nut
Washer
Plate
A: 10"
B: 25"
A
B
The following parts are available for re-order if damaged or missing.
Fitter Screw (A)
Wire Nut (B)
Spare Parts List:
S
o
c
k
e
t
T
u
b
e
M
o
u
n
t
i
n
g
H
a
r
d
w
a
r
e
(
1
S
E
T
)