Assembling & Installation Instructions

ManualsBrandsGracie Oaks ManualsCandle-Style ChandeliersBellefonte 3 - Light Candle Style Wagon Wheel Chandelier

For Hanging Mount Light Fixture

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old

fixture and all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts

on a clear area. Take care not to lose any small parts

necessary for installation.

3. Raise the end of pipe screw(C) part way into the center

screw hole of the single bar(D), lock it securely with the

lock washer(B) and hex nut(A). Attach the single bar to the

Junction Box with the two box screws(E) as shown. The

side of the cross bar marked "GND" must face out. The

junction box is not included.

4. By measuring, determine correct wires length of needed for

proper hanging height, then lock it securely with small screw(H).

Press the ‘cable lock’ and adjustment steel cable to the

proper length. Slide safety lock to the proper position,

lock it securely with the screws. ADVICE: if you do not

adjust hanging height later, you may properly cut the

wire and steel cable is too long parts.

5. While holding the canopy(F) towards the ceiling, connect

the electrical wires as Shown in Fig.2, making sure that all

wire nuts are secured. You may have to wrap the

connections with electrical tape. If your outlet has a

ground wire (green or bare copper), connect the fixture

ground wire to it. Otherwise connect fixture’s ground wire

directly to the Mounting strap with the green screw

provided. After wires are connected, tuck them carefully

inside the Junction Box.

6. Raise the canopy(F) onto the junction box, aligning screws

on single bar with mounting holes in canopy and lock it

securely with the round nut(G). Return the lamp holder(I)

to upright position, raise the candle sleeve(J) insert the

lamp holder.

7. Install the light bulbs in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE

SPECIFIED WATTAGE !

Your installation is now complete. Return power to the

junction box and test the fixture.

Fig.1

Cable

Lock

Safety

Lock

Junction Box

(Not included)

Fig.2

Page 1

White or

HOUSE

Black

WIRES

(Hot)

Smooth

FIXTURE

WIRES

Black or

Ribbed

WIRES

FIXTURE

Bare Copper(Ground)

FIXTURE

WIRES

Copper

(Ground)

HOUSE

(Neutral)

WIRES

White

Bare

Green or

WIRES

HOUSE

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT

of 1