installation of foldingtable

Using Long Bolts (C) with Flat Washer (F) , as shown in the picture (1) and Short Bolts (D) & Flat Washer
(F) with Sleeve Nuts (E), as shown in the picture(2).Tighten with using the Allen Key (G).
NOW, go back to all bolts previously loosely fasten, drive in and tighten all bolts in sequential manner.
This sequential manner will reduce possible distortion of frame.
CAUTION !! DO NOT OVER TIGHTEN.
OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
SLOWLY TIGHTEN ONLY UNTIL SECURE AND STABLE.
Step 4
Step 5
You are now at the FINAL stage of this assembly.
In a sequential manner, drive in and fully tighten all bolts.
Thereafter, turn the table right way up.
The Table now is ready to be used.
5 OF 6