CAUTION: You must read this before you proceed.
No. Description Qty A Table 1 B Leg Connector 1 Description Qty C Long Bolts (M6x55mm) 5 D Short Bolts (M6x35mm) 7 E Sleeve Nuts (M6x18mm ) 5 F Flat Washer (M6x1.5mm) 12 No.
Parts Introduction This Table has multiple parts and may require up to 20 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various Table parts into perspective. Please read through the instructions herebelow to familiarise yourself with the parts and steps before assembly. Step 1 A. Table B. Leg Connector Place the Table (A) on a clean, non-marring surface. Take out Leg Connector(B) and Hardware.
Step 2 Place the Table (A) with the fabric face skywards onto a clean, soft surface to avoid any scratches or damages to the product. Lift legs upright in degrees until the braces are locked, as shown in the diagram. Step 3 Attach the Leg Connector (B) to the Table (A). You may need to apply a little pressure to the Legs - pushing outwards, so as to enable the Leg Connector (B) to be slotted into position.
Step 4 Using Long Bolts (C) with Flat Washer (F) , as shown in the picture (1) and Short Bolts (D) & Flat Washer (F) with Sleeve Nuts (E), as shown in the picture(2).Tighten with using the Allen Key (G). NOW, go back to all bolts previously loosely fasten, drive in and tighten all bolts in sequential manner. This sequential manner will reduce possible distortion of frame. CAUTION !! DO NOT OVER TIGHTEN. OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT. SLOWLY TIGHTEN ONLY UNTIL SECURE AND STABLE.
OF 6
