Assembly Instructions

You are now at the FINAL stage of this assembly.
In a sequential manner, drive in and fully tighten all bolts.
Therefore, turn the table right way up.
The table now is ready to be used.
Step 4
Step 5
Using Long Bolts ① with Spring Washer ④ & Flat Washer ⑤, as shown in the picture (1) and Short
Bolts ②, Spring Washer ④ & Flat Washer ⑤ with Sleeve Nuts ③, as shown in the picture (2).Tighten
with using the Allen Key ⑥.
NOW, go back to all bolts previously loosely fasten, drive in and tighten all bolts in sequential manner.
This sequential manner will reduce possible distortion of frame.
CAUTION !! DO NOT OVER TIGHTEN.
OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
SLOWLY TIGHTEN ONLY UNTIL SECURE AND STABLE.
Page 5 OF 6