Assembly Instructions

Step 3
Lift table legs upright in degrees until the braces are locked, as shown in the diagram.
Attach the Leg Connector (B) to the Table (A).
You may need to apply a little pressure to the Legs - pushing outwards, so as to enable the Leg
Connector (B) to be slotted into position.
Using the Short Bolts ② with Spring Washer ④ & Flat Washer ⑤, tighten the bolts by using the Allen
Key ⑥, as shown in the diagram.
WARNING!! DO NOT OVER TIGHTEN.
OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
Step 2
Page 4 OF 6