CAUTION: You must read this before you proceed.
No. Description Qty A Bench 1 B Leg Connector 1 Description Qty C Long Bolts (M6x55mm) 3 D Short Bolts (M6x35mm) 7 E Sleeve Nuts (M6x18mm ) 5 F Flat Washer (M6x1.5mm) 10 Allen Key 2 No.
Parts Introduction This Bench has multiple parts and may require up to 20 minutes to assemble. To give you an overview of the Bench parts, the above picture is to help you put the various Bench parts into perspective. Please read through the instructions herebelow to familiarise yourself with the parts and steps before assembly. Step 1 A. Bench B. Leg Connector Place the Bench (A) on a clean, non-marring surface. Take out Leg Connector(B) and Hardware.
Step 2 Place the Bench (A) with the fabric face skywards onto a clean, soft surface to avoid any scratches or damages to the product. Lift legs upright in degrees until the braces are locked, as shown in the diagram. Step 3 Attach the Leg Connector (B) to the Bench (A), You may need to apply a little pressure to the Bench Legs - pushing outwards to position the Leg Connector (B). Using the Short Bolts (D) with Flat Washer (F), tighten the bolts by using the Allen Key (G), as shown in the diagram.
Step 4 Loosely affix by using Long Bolts (C) with Small Flat Washers (F), as shown in the picture (1) and Short Bolts (D) &Flat Washers (F) with Sleeve Nuts (E), as shown in the picture(2). Tighten with using the Allen Key (G). NOW, go back to all bolts previously loosely fasten, drive in and tighten all bolts in sequential manner. This sequential manner will reduce possible distortion of frame. CAUTION !! DO NOT OVER TIGHTEN. OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
OF 6
