Installation & Assembly

Step 4
Step 5
Turn the table upside down on to a soft surface that does not scratch
the tabletop.
Attach Inner Table Leg with Pre-attached Leveller(C) and Outer
Table Leg with Pre-attached Leveller(D) to the mounting position on
the table top(A) with bolts(①), spring washers(③) and washers(②)
by spanner(⑥).
Do not over tighten.
Caution: you may need 2 adults to turn the table top A upside
down.
Turn the Table rightside up.
Adjust the pre-installed Leveller until the Table is level with the
ground.
Then, proceed to tighten all Bolts and Nuts.
Your table is ready for use.
Caution: This Table can only be used on a flat, level surface.
A(Table Top)
Table Leg
⑥
①
③
②
Adjust height
for balance
Adjust low
for balance
Page 5 OF 7