Installation & Assembly

 Page:  ‐3‐/4
4. Carefullypasswiresthroughthemountingplate(A) 
Securemountingplate(A)tooutletboxwithoutletboxscrews(B)
NOTE:thesideofmountingplatemarked"GND"mustfaceout



5. Makewireconnections
   Connectwiresasbelowwiresconnectingshown.TAKENOTEOFYOURWIRECOLOROFFIXTURE,NEVERCONNECT 
WIRETOGROUNDWIRE
Connectgroundwireaccordingtobelowchart  Connectwiresaccordingtobelowchart











Twistplasticwireconnectoruntilwiresaretightlyjoinedtogether,wrapeachconnectorwithapprovedelectricaltapeand
carefullytuckallwiresintotheoutletbox

6. Positionthecanopy(E)overtheoutletbox.Aligntheholes 
 inthecanopy(E)withthemountingscrews,thenattachthe
 canopy(E)usingthepreviouslyremovedballknobs(G).Hand 
tightenuntilsnug.
7. Loosen the stud (F)on the joint to adjust the angle of metal shade(H),
once desired angle of fixture is achieved, tighten the studs(F).
Install bulb (Not included. Please do not exceed the
maximum capacity recommended on the socket.)
8. Checkeverythingisalreadyinstalledproperly,thenyoucouldturnonthelight.Enjoy!