Operation Manual

1. Drive belt next to sprocket

2. Consistency, lets stick to one word-

Securing the belt with Zip ties.

3. Clamping belt in the dropout

4. Clamping belt behind the crank

5. Drive belt above Snubber wheel

6. Stepping on the belt

7. Clamping belt to the frame

8. Using pliers

Illustration 1:

Before mounting / dismoun-

ting the rear wheel

Dismounting the rear wheel

To dismount the rear wheel, you need to follow the steps below one at-a-time.

Separate the Rohlo SPEEDHUB500/14 shifter. Look up the procedure for your version of

the hub in your Rohlo SPEEDHUB500/14 manual.

Loosen the long torque arm (if used in your model) according to the Rohlo SPEEDHUB

500/14 manual.

Push the Snubber wheel to the right latching position on the axle. (Illustration 1)

Illustration 1: before mounting/ dismounting the rear wheel

If applicable, unhinge the bowden cable of the rim brake.

Loosen the quick release skewers or axle nut, and take the wheel from the dropouts.

Remove the belt from the rear sprocket. Make sure you handle the belt carefully according

to the instructions for proper handling of the belt.

Mounting the rear wheel

Check the t of the Snubber in the right latching position of the axle according to

illustration 1 of the instructions for Dismounting the rear wheel. Hang the drive belt over

the bottom bracket of the frame and follow the instructions for Mounting the Gates

Carbon Drive Belt (start at step 4).

rst steps

7. 8.