Operation Manual

Page | 100
GRACE MX II Operating instructions
2.11. Assembly manual, pedal reflectors for Schindelhauer pedals
Operating the vehicle without pedal reflectors is a violation of the StVZO. For this
reason, we recommend assembly of the pedal reflectors.
Preparation
Make sure that all of the required components are present:
•
8x cross recessed screw M4x22mm
•
8x self-locking nuts M4
•
4x mounting wedge outside
•
4x mounting wedge inside
•
4x Reflector housing
•
4x Reflector
•
2x Schindelhauer pedals
Have the following tools available:
•
Cross screwdriver PH2
•
Wrench 7mm mouth width
Work steps
Take the reflector housing and plug the M4
screws into the existing long holes. Then push on
this the mounting wedge.