Manual

40
Hard Reboot
Selecting this menu item will reboot the radio. You can also reboot the radio By unplugging and
pressing and holding the power button until the display turns off, then release the power button.
Get Registration Key
This will display a key that can be used to register the radio on the Grace Digital Audio Customer
portal:
myradio.gracedigital.com
. See the ‘
Registering your radio
’ section of this user manual for
more details.
Clock Set up
Change the time format of the radio, and set the local time zone.
Backlight
Selecting this option will alter the Internet radio’s backlight brightness. Note that in Standby mode
you can use the Menu knob to adjust the back light up or down.
1. After selecting the ‘Backlight’ menu item, the radio will display its list of three menu modes:
‘Inactive’, ‘Active’ and ‘Standby’. These three states are explained below:
• The radio gets into its ‘inactive’ state when there is no button pressed for 30 seconds.
• The ‘active’ state is when there is user activity.
• ‘Standby’ is the state when the radio has been turned off. The standby back light setting can be
reduced to zero (a blank screen).
2. Rotate the knob to highlight the desired menu mode and press SELECT.
3. The radio will now display the current backlight value for this menu mode. You can alter this
value by rotating the knob to increase or decrease it.
4. If you have installed the optional battery pack, setting the display as dim as possible will increase
battery life.
5. For beside use, you can set inactive and standby status to a brightness of ‘0’. This will turn the
display off. Then select the active setting to 1-30 depending on your preference. At any time
during the night you can rotate the Menu knob or press any knob on the radio and the light will
briefly display before going back to the inactive status backlight setting.